The Shuttle-Derived Heavy Lift Launch Vehicle, also known as the High Confidence Heavy Lift Launch Vehicle (or even variations of the "Side Mount Launch Vehicle" or "HLV" or "Not Shuttle-C") is an alternate launch vehicle proposal for the NASA Constellation program. It was first presented on June 17, 2009 by John Shannon, NASA's Shuttle Program manager, to the Augustine Commission which is tasked to review NASA's human spaceflight program.
It is based on the Shuttle-C concept which has been the subject of various studies since the 1980s. Derived from currently used Space Shuttle hardware, i.e. an Shuttle-Derived Launch Vehicle (SDLV), it is proposed to replace the winged Orbiter from the Space Shuttle stack with a simple non-winged side-mounted payload carrier. The designs of the Space Shuttle's External Tank (ET) and the four-segment Shuttle Solid Rocket Boosters (SRBs) would be reused.
According to NASA's John Shannon the HLV can be developed within 4Template:Frac years until the first manned flight occurs. The development program should cost about US$6.6 billion,[1] which is only about 20% of the costs currently estimated for the Ares I and Ares V vehicle development.
Following President Obama 2010 space policy speech at Kennedy Space Center and the NASA Authorization Act of 2010 another HLV program, the Space Launch System, which is also Shuttle-derived, has been selected to replace the Constellation launch vehicles, with the development commencing thereafter.
Origin[]
An unmanned side-mounted concept of the Space Shuttle named Shuttle-C was the subject of various concepts that were investigated between 1984 and 1995.[2] After the Space Shuttle Columbia accident a two-year industry study was prepared in 2004 and 2005 to further investigate the concept in order to replace the Space Shuttle. The Exploration Systems Architecture Study (ESAS) in 2005 also investigated a Shuttle-C option for Project Constellation, however again only in an unmanned version. All these concepts included the side-mounted carrier to be an autonomous spacecraft which would detach from the External Tank after main engine cut-off similarly to the Space Shuttle. Some of the studies included the reuseability of the Space Shuttle Main Engines on this side-mounted carrier. None of the concepts involved in-ascent fairing separation.
The Shuttle-C concept as a cargo only option was not funded in the 1980s and 1990s due to NASA's budgetary constraints. The 2004–2005 industry study provided an updated proposal, which was looked at by ESAS but was ultimately deemed inferior to the Ares I and Ares V option. Crewed side-mounted Shuttle-C concepts were not looked at all in ESAS.
The HLV proposal presented by John Shannon on June 17, 2009 is partly based on the original Shuttle-C proposal but differs considerably from it, mainly due to not using the side-mounted carrier as a separate spacecraft which detaches from the ET and due to proposing to also carry crews on the HLV, not just cargo. The team involved in analysing and designing the HLV design at NASA include about 60 NASA engineers headed by Rick Manella.[3]
HLV specifications[]
The HLV is proposed to be a 4,600,000 pounds (Template:Convert/round kg) vehicle at liftoff with two 4-segment Space Shuttle Solid Rocket Boosters weighing about 2,600,000 pounds (Template:Convert/round kg) providing a total thrust of 5,900,000 pounds-force (Template:Convert/round MN) at sea level, with the currently used Space Shuttle External Tank weighing about 1,660,000 pounds (Template:Convert/round kg) in a fueled stage and a propulsion and payload carrier side-mounted to the vehicle.
This side-mounted carrier includes a boattail carrying the propulsion elements which include 3 Space Shuttle Main Engines weighing about 57,000 pounds (Template:Convert/round kg) in total and the 7.5 meters (Template:Convert/round ft) diameter payload carrier with a separable fairing weighing 51,000 pounds (Template:Convert/round kg). The basic vehicle does not require an upper stage. Orbit circularization for missions to lower Earth orbit or trans-lunar injection burns for missions to the Moon or other destinations outside Earth orbit are provided by the payload which detaches from the HLV after the main ET fuel is depleted.[4]
The only completely new hardware development required for the HLV is the side-mounted carrier. All other components used on the HLV were previously in use with the Space Shuttle. According to John Shannon's proposal the first several flights (up to 6 flights) of the vehicle will reuse spare parts of the retired Space Shuttle fleet and salvage functioning hardware from the orbiters, including existing avionics modules, the Flight Software and the Space Shuttle Main Engines (SSMEs) (Block I flights). Virtually no change to the existing Space Shuttle infrastructure, from the Vehicle Assembly Building to the External Tank barge to the launch pads is required.
Upper stage[]
Although technically not part of the HLV, the proposal envisions that the upper stage which is attached to the payload and rests in the payload fairing for launch shall be a J-2X engine that was under development for the Ares I launch vehicle. It would provide nearly 300,000 pounds-force (Template:Convert/round MN) (vacuum) and has a specific impulse (Isp) of 448 sec. Alternatively The United Launch Alliance has proposed that their Dual Thrust Axis (Lunar) Lander (DTAL) could fit in a side mount payload shroud. The United Launch Alliance proposed ACE 41 and ACE 71 upper stage/fuel depot could also fit inside a side mount payload shroud and the ACE 71 at 75 metric tons (Template:Convert/round short tons) is well within the side mount shuttle derived vehicles payload capacity.[5] This could eliminate the need for evolving the directly shuttle derived vehicle when combined with a fuel depots architecture.
Performance[]
The HLV's 4-segment SRBs deliver a specific impulse (Isp) of 267 sec and a thrust of 5,900,000 pounds-force (Template:Convert/round MN) and burn for about 155 seconds. The SSMEs shall be flown at 104.5% and deliver a specific impulse (Isp) of 452 sec and 1,500,000 pounds-force (Template:Convert/round MN) (vacuum) and burn for about 500 seconds (depending on the mission profile). The payload mass for different missions are as follows:[6]
- Block I vehicle without an upper stage - 79 metric tons (Template:Convert/round lb) (gross) and 71 metric tons (Template:Convert/round lb) (net) to a 120 nautical miles (Template:Convert/round km) × 120 nautical miles (Template:Convert/round km) reference orbit (28.5°) from Kennedy Space Center
- Block II cargo vehicle with an upper stage (mass of upper stage not included) - 90 metric tons (Template:Convert/round lb) (gross) and 81 metric tons (Template:Convert/round lb) (net) to a 120 nautical miles (Template:Convert/round km) × 120 nautical miles (Template:Convert/round km) reference orbit (28.5°) from Kennedy Space Center
- Block II crew vehicle with an upper stage (mass of upper stage not included) - 92 metric tons (Template:Convert/round lb) (gross) and 83 metric tons (Template:Convert/round lb) (net) to a 120 nautical miles (Template:Convert/round km) × 120 nautical miles (Template:Convert/round km) reference orbit (28.5°) from Kennedy Space Center
- Block II lunar missions: 39 metric tons (Template:Convert/round lb) to TLI (gross) with the lunar lander and 35 metric tons (Template:Convert/round lb) to TLI (net)[4] from Kennedy Space Center.
Mission profile[]
In contrast to prior proposals of Shuttle-C, except for the 4-segment SRBs no part of the vehicle is recoverable and reusable. The HLV uses a different flight profile than the Space Shuttle because no loads on wings have to be considered. The payload fairing 23,000 pounds (Template:Convert/round kg) is jettisoned after 185 seconds into the flight at about 57 nautical miles (Template:Convert/round km) altitude in order to improve payload mass of the vehicle. The used SSMEs are not reused and thus can be simplified, but will have to be produced for each vehicle (unlike the Shuttle). For lunar missions, the HLV proposal envisions suborbital staging at 30 nautical miles (Template:Convert/round km) × 120 nautical miles (Template:Convert/round km) of the vehicle to increase mass through TLI (trans-lunar injection) with two burns of the upper stage (a suborbital burn and an additional TLI burn).
Lunar mission architecture[]
While the HLV is designed to provide crew and cargo missions to the ISS, its primary aim is to replace the Ares I – Ares V lunar architecture. The rudimentary mission architecture presented by John Shannon uses a pure Lunar Orbit Rendezvous profile. Two HLVs are launched for the completion of one mission. The first HLV is launched with the lunar lander and immediately places the lunar lander on a trans-lunar injection path. The lunar lander can have a net mass of 35 metric tons after TLI and by itself inserts into a low lunar orbit (LLO). According to John Shannon's presentation in LLO the lunar lander will weigh about 28 metric tons (after burning fuel to get there).[6]
In a second launch, the crew on the Orion spacecraft is launched on an HLV and also immediately propelled to trans-lunar injection. The 20 metric ton Orion spacecraft will however remain attached to the upper stage which inserts the Orion spacecraft into low lunar orbit where it docks with the lunar lander.
Growth options[]
The NASA presentation shows that the HLV has limited growth options to take more payloads into space. While 5-segment SRBs can be used on the vehicle, they will require significant re-engineering of the vehicle and will only yield 7 metric tons more to lower Earth orbit. Other growth options include an upgrade of the SSME to 106% or 109% thrust level and a switch from the J2-x upper engine to an air-startable SSME.[4]
See also[]
- Magnum (rocket), a 1990s Shuttle-derived heavy lift vehicle concept.
- Review of United States Human Space Flight Plans Committee
- Jupiter (rocket family)
References[]
- ↑ Borenstein, Seth (June 30, 2009). "NASA manager pitches a cheaper return-to-moon plan". Associated Press via Breitbart.com. http://www.breitbart.com/article.php?id=D99555S03&show_article=1&catnum=0. Retrieved 2009-07-18.
- ↑ "Shuttle-C". GlobalSecurity.org. http://www.globalsecurity.org/space/systems/sts-c.htm. Retrieved 2009-01-20.
- ↑ kcowing (2009-07-06). "More Internal Validation of Sidemount HLV". NASA Watch. http://www.nasawatch.com/archives/2009/07/more_internal_v.html. Retrieved 2009-07-18.[dead link]
- ↑ 4.0 4.1 4.2 "Shuttle-Derived Heavy Lift Launch Vehicle". Review of United States Human Space Flight Plans Committee. NASA. June 17, 2009. http://www.nasa.gov/pdf/361842main_15%20-%20Augustine%20Sidemount%20Final.pdf.
- ↑ [1]. ULA
- ↑ 6.0 6.1 "Will son of Shuttle-C replace NASA's Ares?". Flightglobal.com. 2009-06-29. http://www.flightglobal.com/articles/2009/06/29/328988/will-son-of-shuttle-c-replace-nasas-ares.html. Retrieved 2009-07-18.
External links[]
- HEFT about Heavy Lift Launch Vehicle
- YouTube: NASA Shuttle-derived Sidemount Heavy Launch Vehicle Concept (First Shown on June 17, 2009)
- Universe Today: Faster, Cheaper (and Better?) Way to the Moon (July 1, 2009)
- San Francisco Chronicle: Backup plan to get NASA to moon cheaper (July 5, 2009)
- United Launch Alliance Lunar lander paper
Template:Rocket families
|
|
This page uses Creative Commons Licensed content from Wikipedia (view authors). |